Gytis Posted September 23, 2008 Share Posted September 23, 2008 Don't use this tool much....so there is no way to have a horizontally aligned single duplex receptacle, as might go in baseboard? Quote Link to comment
gmm18 Posted September 23, 2008 Share Posted September 23, 2008 No it does not look like the "Switch" PIO will let you edit the 3D component, so you would just have to make your own 2D/3D hybrid symbol. It would be very easy though, just draw your 3D receptacle how and where you want it, then place a receptacle symbol over it (turn off 'show 3D detail'), -> select both -> Create Symbol. Quote Link to comment
Gytis Posted September 23, 2008 Author Share Posted September 23, 2008 Ya, done that...but it sure would be nice not to lose the object intelligence. Seems like a common enough condition-I think I'll wishlist. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.