VW 2008 to DWG export

[carpalmer]

exporting drawing (site plan) that has lots of curves and circles and when I open in ACAD 06 the curves come out really faceted, like crude octagons...

I've adjusted my "WMF EXPORT" to 300, but that didn't do anything (don't know what it does)...

any suggestions?!

thx

carpalmer

[russh]

Sounds like the resolution in ACAD is too low. Try the VIEWRES command in ACAD. Type VIEWRES at the command prompt, hit ENTER and then enter a value of 1000 or greater and hit ENTER again. The bigger the value, the smoother the arc.

Edit: you may have to REGEN to see the result, if REGENAUTO is not enabled. Or just zoom all.

Edited February 6, 2008 by russh