Jump to content
  • 0
Sign in to follow this  
D Wood

Designjet 110plus nr prints A2 in portrait mode


I want to print A2 size drawings from the roll feed. Page setup and preview says I'm in landscape mode, but it prints in portrait, so I get an A2 drawing on a square sheet of paper. How can I reconcile the printer to the correct orientation?


David W

Auckland, NZ

VWA 11.5.1

17"iMac, 512MB RAM

Share this post

Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...