bguthrie Posted April 22 Share Posted April 22 Forgive me if this is obvious as I am new here... but is there a method to wrap device connector numbering on the left and right? If I have a 48 port switch and I want the numbering to not be all down one side of the device, can I have the even on one side, and odd on the other? Quote Link to comment
Vectorworks, Inc Employee Nikolay Zhelyazkov Posted April 23 Vectorworks, Inc Employee Share Posted April 23 15 hours ago, bguthrie said: Forgive me if this is obvious as I am new here... but is there a method to wrap device connector numbering on the left and right? If I have a 48 port switch and I want the numbering to not be all down one side of the device, can I have the even on one side, and odd on the other? Hello @bguthrie, You can double click to edit your device and move the sockets as you wish. Additionally, if you are using the Device Builder you can set up the socket positions from there. Let me know if you need any additional info. Best Regards, Nikolay Zhelyazkov Quote Link to comment
Vectorworks, Inc Employee Conrad Preen Posted Thursday at 07:27 AM Vectorworks, Inc Employee Share Posted Thursday at 07:27 AM @bguthrie Also be aware that you can use the ConnectCAD > Renumber ConnectCAD Objects... command to good effect inside devices to get the pattern of socket numbering that you want. Conrad Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.