Question on Tray, Slots and Devices

[bjoerka]

I am using a tray to represent a oneRack from TVone.

The tray is configured to 6HE and 2h and 12v slots.

When i add a device, i.e. a fibre-hdmi converter, the physical dimension of that device change to the space the slot in the tray has to give.

Is there any way that my devices will keep their physical dimensions as defined in the device builder?

 

thx for any advice .-)

 

original device

 

device after dropped to a slot

Edited December 5, 2023 by bjoerka

[Nikolay Zhelyazkov]

Hello @bjoerka,

 

When an equipment is inserted in a rack frame it automatically adjusts its size to fit the number of slots that it has specified. So I do not really think that you can make any manual adjustments here. You can try to change the slot configuration of the tray so that a slot is as close to your size as possible.

 

Best Regards,

Nikolay Zhelyazkov

[bjoerka]

Thank you Nikolay.

Then i´d make a wish to integrate a checkbox to the devices to keep their dimensions when placed into slots .-)

Edited December 5, 2023 by bjoerka