Ryoung Posted August 31, 2023 Share Posted August 31, 2023 Hi all, I'm new to Marionette and I'm trying to figure out if what I'm trying to do is even possible before I go down the rabbit hole trying to figure out how to actually do it. I'm trying to create a backing plate for an edge lit LED sign. My research is telling me that I want to CNC engrave a piece of plexiglass with little circles, but those circles want to be closer together as they get further from the edge of the plexi (and therefore the light source) I an thinking that I can modify the tutorial that placed locus points within a closed polyline. To place a symbol of the circle to CNC within a rectangle (the outline of the plexi). So far I can place the Symbols in a grid, but not sure where two go from here to alter the spacing. Any help would be greatly appreciated. Quote Link to comment
Marionette Maven Marissa Farrell Posted September 5, 2023 Marionette Maven Share Posted September 5, 2023 @Ryoung Can you provide an image that shows an idea of the result you're looking for? Quote Link to comment
Antonio Landsberger Posted September 5, 2023 Share Posted September 5, 2023 @Ryoung Do you want to end up with something similar to this? 2 Quote Link to comment
Ryoung Posted September 15, 2023 Author Share Posted September 15, 2023 Yes. this is what I'm liking for. except the the dots would fill in a square instead of a circle. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.