KenH Posted March 10, 2023 Share Posted March 10, 2023 Hi. I would be grateful if someone could tell me how I can stand a design cube onto its point. I have design the six sides of the cube and grouped them. I now need to stand the cube onto it point. I have going round this issue for the last 6 hours using every tool to carry this out with success. It would be great to know the sequence to complete my design. Best wishes Ken Haken Quote Link to comment
Pat Stanford Posted March 10, 2023 Share Posted March 10, 2023 Go to a side view and rotate the cube 45 degrees to make one edge run along the layer plane. Go to a Front view and use the Rotate tool. Click on the bottom corner (on the layer plane) and then the opposite corner. Drag the rotate extension line so it is vertical. It will be about 35 degrees. 2 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.