Zrasap Posted February 9, 2023 Share Posted February 9, 2023 (edited) Hello, i want to connect a panel connector with rack device, and how can i do this to get the through character "-->" in the direction i need? Thanks! Edited February 9, 2023 by Zrasap Quote Link to comment
Vectorworks, Inc Employee Conrad Preen Posted February 10, 2023 Vectorworks, Inc Employee Share Posted February 10, 2023 @Zrasap Hello, could you post a picture of the situation you are trying to model. Just to make sure I understand the question. Conrad Quote Link to comment
Zrasap Posted February 10, 2023 Author Share Posted February 10, 2023 @Conrad Preen This is your picture from another topic, I'm trying to repeat what is indicated as "denotes bare wire ends for solder or crimp" , but it says that I need to connect the input connector to the output connector when I try to connect the panel connector to the input connector of the device. Quote Link to comment
Zrasap Posted February 10, 2023 Author Share Posted February 10, 2023 I want to get this result, but I can only do it when I change the connector from the output to the input, connect it to the device, and then change the connector back to the output and already connect it to another device Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.