Jump to content
n.gorsuch

Marionette Ramp

Recommended Posts

Hi, I am an exhibition designer (and new here) and would like to develop a "ramp" tool for my work.

Some booths are built up around 10-20 centimetres over the exhibition floor and therefore use a ramp module of about 1-1.5 meters deep to avoid a step.

Eventually I would like to have a BIM module, but I thought I could start with a simple marionette where you type in the desired height and depth of the ramp and the it extrudes along an active path.

I've watched a couple of marionette tutorials but still obviously don't even understand the basics.

Before giving up I just wanted to ask if anyone can give me a tip on how I could continue (perhaps I'm going about it completely the wrong way)

Thanks a lot

Neil

 

ramps.thumb.jpeg.9064f8650d80a5e894812c48b6f1fff8.jpeg

Share this post


Link to post

😲 Oh, thank you so much! This really does help, I'll play around with it a little more, and perhaps get back to if I get stuck again. Thanks again, Neil

Share this post


Link to post

here is a solution (with Ref point) for <extrude along Path>

 

 

Built you an better example.

triangle.vwx

 

Greatings M. Graf

 

 

  • Like 1

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...