Jump to content
  • 3
Jim Smith

Step wall command

Question

Stepping a wall is a pain, so that I generally end up clipping a wall & giving the many walls new X values. It's still a pain.  I would like a tool that allows one to enter a step or series of steps based on X Y & Z values. For example: were a wall to step from 1220 below 00 to  2440 below 00 over in 8 steps over 5M. Pick a start point along a wall & a direction & plug in the values. 

  • Like 2

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...