Kirillljuk Posted April 15, 2020 Share Posted April 15, 2020 Hello! I have problem with linking Vision and Grandma2 on PC. I can connect grandma by MA driving, and my DMX viewer in Vision doesn't show me only 0. But i can't control instruments. I patched 3 moving heads (Clay Paky) but they don't reaction to command from grandma. I don't have many experience with vision and grandma - i'm starting to my education. Thanks for help! Quote Link to comment
Vectorworks, Inc Employee jcogdell Posted April 16, 2020 Vectorworks, Inc Employee Share Posted April 16, 2020 The GMA 2 on PC will not output any form of DMX or DMX over ethernet (artnet, sACN, MAnet and so on) unless you either have MA hardware attached to your PC (a command wing or node) , or you have a Vision Dongle plugged in. This is a restriction of the MA on PC software (all versions). You can order a dongle directly from Vectorworks or contact your nearest reseller/distributor ( LightConverse in the Ukraine, Design Express in Poland or UltiRender in Finland). I am not sure about the cost for one though. 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.