Jump to content
wingchudesign

window design

Recommended Posts

see attached.

want to make a window/door assembly (center) that matches the left configuration.

left configuration - 3x3 grid. right configuration would be the same but the lower right window would be replaced by a door

1. these are custom windows

2. the custom window doesn't allow us to knock out one pane

3. if i introduced multiple windows, the trim would make the spacing not match the left window configuration

4. having no trim is not an option

I've thought about this a lot but haven't come to a good solution.

the only solution i can think of is if i just physically model it the window then place it in a opening and then make the trim after all that.

this seems like a very tedious task so i'm just wondering if anybody could provide a simpler solution....

IMG_20171020_094952.jpg

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...