Jump to content
Sign in to follow this  
The Hamma

10.5 slower tha 10.1.2

Recommended Posts

Just one thing I have been able to pin point about the new version slowness is when I use the Align/Distribute command. My process is to select the objects press CTRL"=" and adjust the dialog and press OK. Then the slowness appears on the next round. I do my selection and press CTRL"=" and press enter immediately after since the dialog has already been set. But the dialog still appears and I must press enter again because I was too quick. I was never to quick in previous versions of Vectorworks the program has slowed down. I was executing this command yesterday on 10.1.2 with no problems.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...