Corner Window

[SharonP]

Hi

On the previous ouse I was drawing I had to do a corner window, and did this no problem... I need to do it again on the next job, but whatever command I used either isn't there any more or I have gone completely mad - which is always possible when working with computers.

Can anyone tell me what command I would have used, and how on earth it can just disappear without me changing the workspace?

I have Windoor but can't seem to figure out if I used it for that window or not.

Sharon

[SharonP]

I've found what I was looking for - the draw windoor command, and although I'm having a few issues making it work properly, I have managed to get what I need.

There was a small arrow beside the Windoor command, but I couldn't get to the command from there, so had to go into the workspace editor and move it so I could see it on my palette. pretty sure I shouldn't have had to do this but I could work out what else to do.

What was the correct solution to accessing that command?

[AlanW]

You don't need to use the wall over and under any more in VW2015, not at computer but as I recall if you choose the mitre on one side and choose fit to wall I think it will auto mitre to the corner.