SharonP Posted June 3, 2015 Share Posted June 3, 2015 Hi On the previous ouse I was drawing I had to do a corner window, and did this no problem... I need to do it again on the next job, but whatever command I used either isn't there any more or I have gone completely mad - which is always possible when working with computers. Can anyone tell me what command I would have used, and how on earth it can just disappear without me changing the workspace? I have Windoor but can't seem to figure out if I used it for that window or not. Sharon Quote Link to comment
SharonP Posted June 3, 2015 Author Share Posted June 3, 2015 I've found what I was looking for - the draw windoor command, and although I'm having a few issues making it work properly, I have managed to get what I need. There was a small arrow beside the Windoor command, but I couldn't get to the command from there, so had to go into the workspace editor and move it so I could see it on my palette. pretty sure I shouldn't have had to do this but I could work out what else to do. What was the correct solution to accessing that command? Quote Link to comment
AlanW Posted June 4, 2015 Share Posted June 4, 2015 You don't need to use the wall over and under any more in VW2015, not at computer but as I recall if you choose the mitre on one side and choose fit to wall I think it will auto mitre to the corner. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.