Kevin McAllister Posted December 20, 2013 Share Posted December 20, 2013 (edited) Has anyone had this happen? The image shows two copies of a sheet layer viewport, the right one rotated 90 degrees. A flattened design layer section appears in the wrong position when the sheet layer viewport is rotated. Is this a bug? It worked fine when I first built it in the original version of VW2014. This problem showed up when I went to edit the file in VW2014 SP2. (The sheet layer viewports have been uncropped and don't fit on the page because I was trying to figure out what was going on. When the crop was active I couldn't see the anomaly.) Kevin Edited December 20, 2013 by Kevin McAllister Quote Link to comment
Vectorworks, Inc Employee PVA - Admin Posted December 26, 2013 Vectorworks, Inc Employee Share Posted December 26, 2013 Could you send in that file to tech@vectorworks.net please? I'll confirm and see if it started happening after of one of the SPs. Quote Link to comment
Kevin McAllister Posted December 26, 2013 Author Share Posted December 26, 2013 Thanks Jim. I'll send it along. All the best for the holiday season! Kevin Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.