Round Walls and Hatch

[Kevin McAllister]

Try this -

- create a round wall with a sweep of 180 degrees.

- give the wall a hatch (in my case its by class). The hatch shows as expected.

- change the sweep to 360 degrees. The hatch disappears.

Is this a bug? Or is there some other reason why I can't do this?

(I'm designing an exhibit that requires a round space in the middle of an exhibit hall.)

I'm seeing the same behaviour in both VW2013 and VW 2014.

Thanks,

Kevin

[PVA - Admin]

Yup, identical results here.

Doesn't occur when I assign the hatch directly to the round wall, but if I use class attributes to assign the hatch it vanishes at a sweep of 360. Fine at 1.0 through 359.99, but no hatch at 360.

Submitting this as an issue now. Thank you.

[Kevin McAllister]

Thanks Jim. Much appreciated.

KM