PSarch24 Posted November 8, 2004 Share Posted November 8, 2004 i was given a design project in which i was supposed to re-design a bus shelter, and the structure which i have come up with had the main wall in the back curves in elevation and in section and i have not been able to find out how to create this. I tried to create the wall first in elevation and then try to move the wall in plan but i could not find a command. I also tried subtracting solids but could not get that to work, so if someone could help me out it would be greatly appreciated. Quote Link to comment
propstuff Posted November 9, 2004 Share Posted November 9, 2004 It sounds like using the Loft Tool to create a surface that joins 2 or more curves, and then the Shell Tool to give it thickness would do what you want, but it'a a bit unclear from your description the shape you're trying to achieve. N. Quote Link to comment
PSarch24 Posted November 9, 2004 Author Share Posted November 9, 2004 Thank you for your response, and sorry for the inaccurate discription, i will try to describe it better here. From looking at the wall in the front view, it starts out short (4 ft) on the left side and smoothly curves upward to a height of 16 ft at the far right. In plan view, that same wall does a somewhat "S" curve, and its this "S" curve that i do not know how to create. I created my wall in front view so that i would be able to get the correct heights/curves of the wall, but now that i have this, i don't know how to create the "S" curve of this wall in plan view, so if someone has any advice on what to do it would help me out a lot, thank you. i hope that this discription gives you a better description of what i am trying to do here. Quote Link to comment
tom kyler_dup1 Posted November 10, 2004 Share Posted November 10, 2004 Maybe something like this? [ 11-10-2004, 12:06 AM: Message edited by: tom kyler ] Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.