Jump to content
Sign in to follow this  
Hen

Slope in 3D Landmark

Recommended Posts

Can anyone advise how I can extrude a slope so that is shows up in a 3D view? ie one end of the extrude needs to be higher than the other. It should look like the ramp from the side but solid.

Help!??

Thanks Hen

Share this post


Link to post

You might try switching to a front or side view, draw the profile, Model>Extrude > enter the width of the ramp.

hth

michaelk

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...