r6dink Posted February 22, 2010 Share Posted February 22, 2010 I'm using the 2008 SP3 and I can't seem to figure out what is going on here. I must be missing something, but when I try to resize a wall all I end up doing is dragging the wall out of place. I am looking to resize the wall and have the other attached walls resize automatically. I know I have done it before. So anyone have any advice? Thanks in advance. Quote Link to comment
michaelk Posted February 22, 2010 Share Posted February 22, 2010 Make sure the 2D selection tool is in "Interactive Scaling Mode" On the Mode Bar it's the one with a single set of diagonal arrows. hth michaelk Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.