NigelShaw Posted January 26, 2007 Share Posted January 26, 2007 Hi, i know you can snap to a tangent but i need to create a 3 point circle that is defined by snapping to 3 tangents. in other words, i am setting out a curved unit. i have 3 exterior circles to create the outside curves and i need to fit 1 circle that fits to the tangent of the three other circles to create my inner curves running off the tangent. how can i do this? regs, NS Quote Link to comment
panthony Posted January 26, 2007 Share Posted January 26, 2007 Nigel, Using the 3 point mode draw a circle from the centers of your 3 existing circles. That new circle will give you the center axis from which to draw lines back to the 3 origninal circles where the intersection of the the new lines of axis will determine the tangent points for all three circles. See Below Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.