Ericoxer Posted January 8, 2007 Share Posted January 8, 2007 Yesterday i went to continue on a project. I started up VW, only to get an error that the software coulld not be found. I made sure that the dongle was installed and lit up and tried starting again, same issue. After a while of doing this, i decided to reinstall the software, and the dongle driver. Still no luck. Running MacOS X 10.4.8, VW 12.5. any ideas? Quote Link to comment
Guest Posted January 8, 2007 Share Posted January 8, 2007 What is the exact message you receive when launching VW? Quote Link to comment
Ericoxer Posted January 8, 2007 Author Share Posted January 8, 2007 "A vectorworks dongle could not be found. Make sure that the dongle is connected and that all required drivers have been installed. Vectorworks will now quit." Like i said, the dingle is in the computer a lit up. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.