Jump to content
  • 0
Sign in to follow this  
C. Deel

arcs printing as long straight lines

Question

Occasionally (usually on documents imported from VW9) we see some of our arcs change into straight lines that run vertically the length of the sheet.

This usually happens on arcs that have been duplicated.

It happens on both paper output and PDF output as well.

We use VW Architect 10.1.2 and Gimp-Print 4.2.5.

Anybody else seen this behavior, or any other problems with printing arcs from the above setup?

Thanks,

Chris

Share this post


Link to post

0 answers to this question

Recommended Posts

There have been no answers to this question yet

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...