Michael Siggers Posted April 3 Share Posted April 3 Hi Would anyone be able to shed any light on why there is a red rectangle in my Design Layer Viewport, shown in the attached screenshot. All references are up to date. Kind regards Mike Quote Link to comment
Michael Siggers Posted April 3 Author Share Posted April 3 So, found the cause. The Terrain needed updating even though I had made no changes to it, although I did relocate the whole model to the Origin as it was causing problems with the display, showing loads of lines all over the surfaces. I'm therefore assuming the terrain required updating because of this. Mike Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.