I'm trying to work out a way that I can show only portions of a large referenced building (without creating a lot of masking rectangles around the drawing) and it occurs to me that this ability is right under VWorks' nose. If there were a transfer mode (similar to overlay, paint or invert) that would allow filled objects to reveal layers underneath them, I could create a view layer on top and draw filled rectangles (or other filled polygons) that revealed the layers underneath. I was playing with a variety of layer transfer modes above and below each other, but could not come up with the desired effect with the given transfer modes. This would be a very easy, but very valuable implementation.
...also bring back the "single click extend" option.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
GJ
I'm trying to work out a way that I can show only portions of a large referenced building (without creating a lot of masking rectangles around the drawing) and it occurs to me that this ability is right under VWorks' nose. If there were a transfer mode (similar to overlay, paint or invert) that would allow filled objects to reveal layers underneath them, I could create a view layer on top and draw filled rectangles (or other filled polygons) that revealed the layers underneath. I was playing with a variety of layer transfer modes above and below each other, but could not come up with the desired effect with the given transfer modes. This would be a very easy, but very valuable implementation.
...also bring back the "single click extend" option.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.