Multiple-Story Wall Height

[TMM]

I am buiilding a 3d model in vectorwork. 

In the attributes of the wall, I chose the wall top bound to be at "Top of Slab (Story Above)". 

However, this wall only extends to the second floor . 

In reality, this wall is a 5-story-high wall. I have set up the  stories in vectorwork. 

 

Without manually putting the wall height, could this wall height be controlled by top bound attributes that  could allow it to run to the top of the 5th story?

 

I was a Revit user, so in revit, I just simply choose the wall top bound to be at the specifc story height.  

 

Could Vectorwork also do similar commands? 

 

 

Thanks!