Belleknowlz
-
Content Count
19 -
Joined
-
Last visited
-
Scaling : Can I scale something from square meterage of a poligon?
Belleknowlz posted a question in Troubleshooting
I have a building document and I know the stair meterage of the room and the stairs, but I was just wondering if there was a setting on vectorworks if I don't know the meterage of each side of the polygon? -
How can I do these fixtures on the wall or ballistrade?
Belleknowlz posted a question in Troubleshooting
-
I'm a design student at university, and I'm drawing over plans, and I don't know how to draw these walls, could anyone advice the setting I could use?
-
@Tom W. Thank you so much!
-
here is the 2020 vectorworks file. Addiction project v2020.vwx
-
Fab, I'll try and do that now, hang on a second Tom - thanks!
-
I know they have to be on the same layer, I mean, I want to join the walls listed above in the photo's but I don't know how too - I'm drawing over building plans, but the bit where the wall is a corner (like a triangle) I can't join them together. I don't know how to draw the wall, or which wall join to use? Does that make sense?
-
Here is my file - it's on the second and third floors, and I think maybe some on the ground? (where ever the wall isn't attached.) Addiction project.vwx
-
@Tom W. of course, do you want me to link the whole vectorworks file or...?
-
It's the jutty out bits (the triangles which are causing me a nightmare!) Would be SO grateful for any help!
-
Vectorworks 21
-
photo's attatched...
-
I've scaled my building and now it is off of my page, and I can't seem to move it, and whenever I do move it, it ends up changing the size of the walls, and not moving the actual building itself. Images attatched..