It would be nice if the Leader and Trailer fields for dimensions would also recognize the Diagonal or Vertical Stacking preference for dimensions that is set in the "Units" dialog under the "Factional Display for Dimensions" setting.
In our office we use the "Diagonal Stacking" preference, which works great for typical dimensions, but when we enter a fractional dimension in the leader or trailer field, the fraction does not stack the same as all the other dimensions in the same drawing.
In fact, it would be great if there was a similar Fractional Stacking preference for text in general as sometimes we write text blocks that have fractional numbers in them (such as an 11 7/8" TJI floor joist callout) and the fractions look different than the dimensions on the same sheet.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
PeterT
It would be nice if the Leader and Trailer fields for dimensions would also recognize the Diagonal or Vertical Stacking preference for dimensions that is set in the "Units" dialog under the "Factional Display for Dimensions" setting.
In our office we use the "Diagonal Stacking" preference, which works great for typical dimensions, but when we enter a fractional dimension in the leader or trailer field, the fraction does not stack the same as all the other dimensions in the same drawing.
In fact, it would be great if there was a similar Fractional Stacking preference for text in general as sometimes we write text blocks that have fractional numbers in them (such as an 11 7/8" TJI floor joist callout) and the fractions look different than the dimensions on the same sheet.
Link to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.