barkerla Posted February 11, 2001 Share Posted February 11, 2001 I've been trying to generate a DTm with about 50 contours and the computer gets almost finished createing it, then it stops and says errors 9,24 have occured. So it never finished the DTM. Does anyone know what errors 9 and 24 are, and how to resolve this so I can get a DTM? Thanks Quote Link to comment
Guest Posted June 13, 2001 Share Posted June 13, 2001 Yes I faced the same problem when I was using VWA9 . However in VW8.5 I did the DTM as I wanted. Why DTM does not work in VWA9? What is error 9,24 and (coul not find DTMVS record) ?? quote: Originally posted by barkerla: I've been trying to generate a DTm with about 50 contours and the computer gets almost finished createing it, then it stops and says errors 9,24 have occured. So it never finished the DTM. Does anyone know what errors 9 and 24 are, and how to resolve this so I can get a DTM? Thanks Quote Link to comment
Guest Frank Brault Posted June 13, 2001 Share Posted June 13, 2001 Hi osca and bakerla, When converting from earlier versions of the Vectorworks, be sure to run the 'Delete...' command in the DTM Processor chunk of the Sitework menu, so that the old model is cleared from memory before running the 'Site Model...' command. Let me know how you make out... hth, Frank Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.