Jump to content

problems with batch export to pdf

Recommended Posts

I had a problem crop up this weekend as I was trying to put out some drawings for a bid set:

When I looked at the drawing in VW, it looked fine. After I did a batch export to pdf, some of the pdfs appeared rotated 180 degrees on the page. Has anyone else had this experience with VW 2012? Does anyone know what might cause it? In some cases where we were printing a sheet layer with a couple of viewports, only one viewport would have the rotated pdf, where the other viewport's pdf was fine. I should mention the pdfs are in a separate class from everything else on the design layer.

We have done this dozens of time with 2012 and thousands of time in earlier versions without incident, so I am perplexed.


Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...