Jump to content
Sign in to follow this  
jarjones

Front view rulers not matching measurements

Recommended Posts

I have a document with the origin set to a specific point. When I view the file from the front/side/etc. the rulers on the side show measurements based on the 2d origin. Looking at the rulers, that point is 5'11.162 down from 0, so my floor is below zero compared to the rulers. If I make a new extrude however, it puts it on the floor at the correct relationship to the floor.

How do I make my front view floor zero coordinate match my rulers?

I'm back on VW 12

Thanks,

Jeff

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...