Jump to content

Recommended Posts

I needed to create a rounded, amorphous shape and struggled quite a bit with it in VectorWorks, before I decided to try an old version of Cheetah, I purchased a few years back.

I created a basic shape in VectorWorks, exported it to Cheetah through the 3ds format and placed the shape inside a subdivision container in Cheetah.

I was able to achieve my goal in no time at all. It was so easy! But wait: Why did I have to go outside VectorWorks at all?

I wish there was an intelligent subdivision function in Vectorworks. Some people say, subdivision is not an accurate modeling method, but then design is not always an accurate science, so let us bring it in :-)

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...