Random floating walls when printing from V12.5

[sok412]

When I print drawings there is a poched wall floating on the page- it is not on the screen and occurs in different drawings, different locations and happens when printing to the plotter and the printer. I tried updating to 12.5.1 (which sounds like it may have been a mistake) but that has not solved the problem either. Any ideas?

[Guest]

Are you using a Mac or PC?

[sok412]

MAC G4

[Guest]

what os version, what printer?

what happens when you export a PDF file?

What happens when you open the file in preview before printing it?

Edited January 19, 2007 by Katie

[sok412]

I'm using OS 10.4.6 and printing to a HP488CA and a Epson 1280- it happens in both. When I preview or print to .pdf it happens as well.

[sok412]

if I export back to V10.5 I can print fine from there.

[Guest]

Send the file along with a description of the problem to tech@nemetschek.net

[Donald Wardlaw]

A few years back I had a problem like that. Not walls actually, but lines running across the drawing that should not be there. I think one work around was to export the file to vectorscript then reimport.

Regards,

Donald

[sok412]

Thanks. Actually I had a problem like this with 10 as well. Then it was huge arcs that appeared across the drawing when printed- but not always like this. That could usually be solved by taking arcs in the drawing and converting to lines a few at a time until the lines went away.