["Cut to site model" - should not be default, but an option..]

I cannot see why the "Cut to site model" should be checked as default, and not be something you could check when you need it. It would be so much easier if it just was unchecked from start. @Knut Andreas @Scott Campbell @fsaetre

[Possibility to put out contour labels along a polyline]

@Scott Campbell I think because it's my question I don't have the possibility to vote up my own suggestion, but I hope everyone else does 🤩

[Possibility to put out contour labels along a polyline]

@aage.langedrag I know about that function, it works quite well, but because it takes forever, around a minute to put out a single label (it's reported to Scott who have buglisted it) to put out labels I think they could expand the possibilities to put out labels 🙂

[Possibility to put out contour labels along a polyline]

It would be great to have the possibility to add contour labels on the site model just by clicking out a polyline and the the labels appear where the poly line crossed the contours. This works very well in AutoCAD, and is an easy way to add a lot of contour labels instead of clicking out one by one. Should be possible to add and remove vertex from the polyline, and move them, to adjust the placement of contour labels later.