magnusboyle

Thanks, bcd! That did the trick.

Hi! I have ran into a small problem. I've imported a set design from sketchUp into VW, and the carpenters now told me that the general width of the design is somewhat smaller. So, I want to cut out a section right down the middle of the design with a width of 550mm. Problem is, I just can't seem to figure out how! I've tried cut/slice tool, making an extruded box and the "subtract solids" function, etc. Also, being imported geometry, I find it difficult to both edit the model and retain texture, etc. Any quick solution to this?? VW-File included. VW2024 Set design no thrust.vwx

I actually figured it out.. Rookie mistake: used the wrong symbols... Thanks though!

Hi! My equipment summary key is not showing any counts. Any obvious reason for this?

Hi! I am importing a DWG from capture (www.capture.se) and it looks right in 3D. In Top plan 2D though, it has a lot of clutter. It's not a new issue for me, but I never really solved it very well. Anything I'm missing here?