col clipper

I wish to show finished levels of the top of hardscape at certain points. The only option for a stake object appears to be Mode 'Set elev to site model' which then only indicates the height to the underside of the hardcape object (if hardscape set to cut site model). The results appear to be the same if I use Mode 'Site modifier object" Is there a way to set or offset the stake object to the top of the hardscape thereby showing the hardscape finished level ? Perhaps a workaround ?? I would prefer not to use the stake as a 2D/3D object only to show the hardscape level as this

Many thanks Tom... The answer was so simple that I just did not see it ! Now lets progress this a little futher.. I now have a group of light fittings (including interconnectiing wiring) that resizes when I drag the group handles. I would like to add a light switch symbol connected to this group via a constrained 'rubber line or curve ' (to represent wiring). Any ideas how I can create the wiring 'rubber line or curve ' that will resize as I drag the light switch symbol to its position ?

Is it possible to constrain symbols in a grid pattern. I would like to be able to produce a generic downlight layout (4 lights symbols in a square) so that I just need to drag the square larger or smaller to suit the room size ?

I have been able to set up and configure a window graphic legend to suit my drawing format but am unable to combine like window configurations in a single cell . Can anyone offer any insight into the 'Report By' & 'Sort' parameters required under 'Define Legend Source' in order to achieve this ??