3D Sectional Viewport (not perspective)
Is there a way to show a 3D sectional viewport similar to the image below?
I have used the clip cube. If I create a viewport is say right isometric then the VP shows the entire structure, note the cropped view as in image.
If I use the create sectional viewport then the view is either perspective or if using oblique cavalier then only one direction of view.
So I actually faced this issue previously and was able to get some success with somewhat of a workaround.
Hopefully the screenshots below make this more clear, but essentially, you take the "generate section viewport from clip cube", and dump that on a design layer as a DLVP. This gives you a section viewport (with live cutting & hatching on one side), but you also get cuts on other sides that are cropped by the clip cube. You can then manually add in 3d hatching on these other s
