Sam Lee Posted October 19, 2013 Share Posted October 19, 2013 (edited) Normally our documents are named something like JA001 - [Dining Room Layout].pdf This is made up from the drawing number then the sheet name and is made into a pdf by using file > publish. Is there a way to also get the revision number into the pdf title when using the publish command, so it would be something like this below ? JA001 - [Dining Room Layout] - 1.1.pdf Edited October 19, 2013 by LLI Design Quote Link to comment
0 Sam Lee Posted May 1, 2014 Author Share Posted May 1, 2014 Is there any update on this ? Quote Link to comment
Question
Sam Lee
Normally our documents are named something like
JA001 - [Dining Room Layout].pdf
This is made up from the drawing number then the sheet name and is made into a pdf by using file > publish.
Is there a way to also get the revision number into the pdf title when using the publish command, so it would be something like this below ?
JA001 - [Dining Room Layout] - 1.1.pdf
Edited by LLI DesignLink to comment
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.