The existing command is somewhat inconsistent I think: In "linear" mode, the number you enter yields the number of objects created; in rectangular and circular modes, the same numbers refer to the total end result.
The command works on the basis of the object center, yet there's no way I know to snap to the center, except for making the object into a symbol and adding a locus at the origin. Could the command show the center by adding a locus and allowing the user to move it? This would address one of the long-standing wishlist items I think.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Carl Burns
The existing command is somewhat inconsistent I think: In "linear" mode, the number you enter yields the number of objects created; in rectangular and circular modes, the same numbers refer to the total end result.
The command works on the basis of the object center, yet there's no way I know to snap to the center, except for making the object into a symbol and adding a locus at the origin. Could the command show the center by adding a locus and allowing the user to move it? This would address one of the long-standing wishlist items I think.
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.