Two files I just worked up (VectorWorks 8.5.1 / 1 file is 168k, the other 468k, no 3d) won't print to our HP Design Jet 1055CM. VectorWorks "unexpectedly quits, error -11" just as the file spools up. I cleaned up both files; deleted unused stuff in margins, deleted unused layers etc, but no change. I then put the files on another machine and they printed fine.
Two other files, created from the same template also printed fine.
The machine I am using is a Mac G4 with 128 MB, 10GB drive w/4.5GB available. Virtual Memory is on, set at 250 MB.
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
MacDaid
G'day VectorFolk,
Two files I just worked up (VectorWorks 8.5.1 / 1 file is 168k, the other 468k, no 3d) won't print to our HP Design Jet 1055CM. VectorWorks "unexpectedly quits, error -11" just as the file spools up. I cleaned up both files; deleted unused stuff in margins, deleted unused layers etc, but no change. I then put the files on another machine and they printed fine.
Two other files, created from the same template also printed fine.
The machine I am using is a Mac G4 with 128 MB, 10GB drive w/4.5GB available. Virtual Memory is on, set at 250 MB.
Anyone have any suggestions?
Thanks!
Link to comment
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.