All of the arrow connections follow a direction of signal flow which is fine.
Sometimes you may draw a connection backwards, how do we flip this cable direction?
Also you can adjust the length of an arrow connection by the handle (for each cable individually).
Do we have a method of selecting a set of arrow connections and adjusting the length so that they all align? (this is currently quite painful). Especially if you take sometihng in or out of a rack etc and it resets everything (or some of the cables) that you previously aligned.
Also when selecting large numbers of arrow connections on a single page it will highlight all devices but will sometimes detatch arrow connections or datatags which would normally move relatively with the device. (Annoyingly its not always that this happens).
Connector Arrows
in ConnectCAD
Posted
All of the arrow connections follow a direction of signal flow which is fine.
Sometimes you may draw a connection backwards, how do we flip this cable direction?
Also you can adjust the length of an arrow connection by the handle (for each cable individually).
Do we have a method of selecting a set of arrow connections and adjusting the length so that they all align? (this is currently quite painful). Especially if you take sometihng in or out of a rack etc and it resets everything (or some of the cables) that you previously aligned.
Also when selecting large numbers of arrow connections on a single page it will highlight all devices but will sometimes detatch arrow connections or datatags which would normally move relatively with the device. (Annoyingly its not always that this happens).