sarracenia
-
Posts
3 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Articles
Marionette
Store
Posts posted by sarracenia
-
-
I'm new to the boards, so hello! I'm back into VW after some time away, and a little rusty.
I seem to have lost my "u" key shortcut for toggling through the different modes of, say, drawing a polyline. I've tried searching to see what command the "u" key (typically) corresponds to, in order to fix it in my workspace editor, but I have not found a solution.
Any ideas? Thanks in advance.
-
Is it possible to configure dimensions so that my layout plan is dimensioned in, say, meters, and my detail drawings are dimensioned in millimeters? I do not want to see both meters and millimeters for each drawing (as would happen if I turned on dual dimensioning).
Toggling through modes using "u" key
in General Discussion
Posted
Great, thanks!
Where can I find out what the other mode groups refer to?