Jump to content
  • Sign in to follow this  

    Connecting Martin M1 console to Vision


    PVA - Jim

    There are a few things you need to know in order to properly configure the Martin M1 Console for it to work properly with ESP Vision. 

    This discussion is valid for the following configurations: 

    Martin M1 Console to Vision 3.0 MAC 
    Martin M1 Console to Vision 2.3 PC 

    CONFIGURE THE NETWORK: 
    To begin, make sure that the IP addresses assigned to the 2 computers are on the same subnet. What this means, is that you must establish a valid TCP/IP connection between the 2 computers for Artnet to work. Here is a sample that will work: 

    Martin M1 Console (automatically set by console): 
    IP Address: 2.186.2.66 
    Subnet Mask: 255.0.0.0 

    ESP Vision machine (manually set to match console): 
    IP Address: 2.186.2.99 
    Subnet Mask: 255.0.0.0 

    It is very important that the Console and Vision machine both be on the same IP subnet AND the Subnet Mask MUST BE 255.0.0.0. Any other value in the Subnet Mask will cause the connection to be intermittent and fail.

    Edited by JimW



      Report Article
    Sign in to follow this  


    User Feedback


    There are no comments to display.



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Restore formatting

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...