Red box appears in model after SP4

[MHBrown]

I just upgraded VW 2022 to SP4 on a MBP 16" i9. All of a sudden, this red square has appeared on one of my extrudes. I cannot delete it and it appears in the extrude edit window, too. Anyone know what it is?

Thanks,

MHBrown

[Jesse Cogswell]

It looks like an edge selection highlight for applying something like a fillet or chamfer.  I've noticed in VW in the past couple of years that every once in a while, a selection highlight will get "stuck" and not go away.  Restarting VW is usually the way I fix it.  If it goes away after a restart, you can likely ignore it.  You might also try seeing if it appears in a Sheet Layer Viewport, just for the sake of curiosity.

[MHBrown]

Thanks. I think it was a selected face when using the texture apply tool. If you select a single face it shows a the red outline I was seeing. The problem was that it would not go away no matter what I did. I finally went back and deselected the outlined face. Apparently, the texture tool does not release when clicking in the drawing or hitting the "x" key.

Thanks for your help!

MHBrown