Jump to content
Sign in to follow this  
Josh Schulman

raked stage floor

Recommended Posts

I am trying to make a stage floor with a 3? rake to it. When I build the object in 2-d mode (it is a little complex with a large curved apron) and extrude it, the texture that I appply to it appears on the extruded side, not on the top. Any thoughts?

Joshua L. Schulman

Share this post

Link to post


I have actually seen this in a few cases, but we were not exactly able to pin down the cause. What we did instead, was convert the extrude into 3D polygons.

This will create a group, which can be broken apart into individual 3D surfaces. These surfaces can all be textured and mapped separately giving a fine level of control

Matthew GiampapaTechnical Support

Share this post

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  


7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114


© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

  • Create New...