Jump to content
Sign in to follow this  
TiTaNiuM sAMuRai

wall edges

Recommended Posts

Is there a way to turn off the top/bottom and side edges/caps of a wall that appear in a 3D view?

case 1: Let's say you have inserted 3 windows, with overlapped mullions, so that it appears as though you have a 3-pane window. The wall cap will appear on each side of each window, even though there should be no wall at that point.

case 2: Let's say you have a two-tone wall, with a window intersecting the dividing line. The most straightforward way is to make a lower wall and an upper wall, and to insert the window in both, at the same location, but with symbol height values that cause the window in the top wall to stick out below and vice versa for the window in the lower wall. However, the bottom face/cap of the top wall runs straight through the window, in addition to wrapping around the window's bottom outline (if you were to remove the lower wall to take a look).

Share this post


Link to post
Guest

You can't turn off the top and bottom caps of a wall. You can turn off wall caps thru the Object Info Palette. Select the wall, from the OIP there is a drop down box that says "Caps" - you can select one of 4 settings - None, Start, End, Both.

Share this post


Link to post

Hi I've had the same situation with garage doors. where the door passes through the bottom of the wall and below the top of the foundation there is a line through the door when the model is rendered.

Mike

Share this post


Link to post

quote:

Originally posted by mike46:
Hi I've had the same situation with garage doors. where the door passes through the bottom of the wall and below the top of the foundation there is a line through the door when the model is rendered.

Mike

In VW 9 You can also reshape the bottom of the wall. Use the 3d reshape tool and add a peak to each bottom corner of your garage door.Makes sense?

Share this post


Link to post

quote:

Originally posted by TiTaNiuM sAMuRai:
case 1: Let's say you have inserted 3 windows, with overlapped mullions, so that it appears as though you have a 3-pane window. The wall cap will appear on each side of each window, even though there should be no wall at that point.

A simple solution is to make a symbol containing the three windows, and insert that into the wall.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...