Jump to content
Sign in to follow this  
Ed Dunn

Incandescent Fixture

Recommended Posts

I am trying to produce a fan symbol out of the incandescent light tool. I can type an "F" into the Config Label field but it winds up outside the circle. When I enter a zero in the x and/or y field (default = 1") and press enter, the field changes to a -36' or some other similar figure and the "F" winds up off the sheet. VWA 11 did this jut fine.

Share this post


Link to post

There is a fan symbol in HVAC_Equipment in the resource browser, see if it will work for you.

Share this post


Link to post

Thanks for that. I will use that symbol for now but I think it would still be a good idea if the problem were fixed so that the fields worked as designed.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

 

7150 Riverwood Drive, Columbia, Maryland 21046, USA   |   Contact Us:   410-290-5114

 

© 2018 Vectorworks, Inc. All Rights Reserved. Vectorworks, Inc. is part of the Nemetschek Group.

×
×
  • Create New...