Can we adjust facia thickness? Also, adjust all the design layer cut plane other than using clip cube to manually do the horizontal cut plane?

[Rishie]

 

How to adjust fascia thickness?

 

How to adjust cut plane height for floor plan?

 

 

[Pat Stanford]

There is no way to adjust the Cut height of Top/Plan view.

 Try Create Horizontal Cut Section Viewport and set the Cut Plane height of that.

 

[Rishie]

Thanks Pat, is there any way to adjust roof fascia thickness?

 

[Guest Wes Gardner]

@Rishie - yes there is ...once the roof's been created you can adjust the thickness from the OIP - see attached.

 

I typically model fascias separately from the roof but that's just me - I feel I have more control that way...

 

Wes

 

 

[Rishie]

Thanks Wes

[Megan M]

On 3/20/2022 at 8:31 AM, Pat Stanford said:

There is no way to adjust the Cut height of Top/Plan view.

 Try Create Horizontal Cut Section Viewport and set the Cut Plane height of that.

 

I thought you could go into the design layer properties and Enable Cut Plane Elevation for that layer, and then create a viewport for a sheet layer. However,  I've tried this recently , to prevent overhead my wall cabinets from showing up on a kitchen plan and it hasn't worked. Is this feature used for something else?