Removing connector panels from equipment schedule

[livespace josha]

I have a worksheet that populates with device name, make, model, location, page number, and some custom fields for serial number and IP address

 

However, this report also pulls connector panels because they become devices once they are in the design layer. 

 

Is there a fancy script or criteria that I can use to omit these from my report? I'd prefer this to be something native that I don't have to think about or remember to do! I have a work-around in mind that could use Data Manager, but that might be a plan B.

[Pat Stanford]

Is there a field that specifies the connector panels?

 

If so an added criteria of Record.Field Is Not (whatever the specifier is) should remove them from the report while leaving everything else.

[aheininen]

I have used this criteria on worksheet. This assumes that you don't specify Make to your panels.

[livespace josha]

perfect! I had to change the criteria to say "is not" "blank"