Jump to content
  • 0

Viewport naming issue


Bertf

Question

Hi,

 

I have the following issue:

When I create a 2nd viewport on sheet 1 and the checkbox "Name viewport as Dwg No./Sheet No." is checked. It receives the name "2/1".

 

image.png.3e406677ba15d27299d4ddaef05d5f82.png

 

When I then duplicate this viewport on this sheet, (just to change some visible classes for example). The name of the duplicate is 2/2 and not 3/1 as one would expect:

image.png.b1e8cdb305be1502c75daa897da89336.png

 

This gives the issue that when I create a 2nd viewport on sheet 2 with the auto naming checkbox selected that I get a naming conflict because 2/2 already exists on sheet 1...

image.png.47ea8e2e3bc54e6cb2a56d4a63c36e5b.png

 

 

So is it possible to fix this that duplication of a viewport changes the name according to the autonaming convention "dwg no/sheet no"?

 

Or even better in my opinion: Change the auto naming of a viewport to "sheet no/dwg no", then the duplicate viewport logic can remain the same.

 

 

Thanks,

Kind regards,

Bert

 

 

 

 

 

Edited by Bertf
Link to comment

1 answer to this question

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...